crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

iPod Nano 3rd Generation バッテリーの交換

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:05crwdne2931653:0
iPod Nano 3rd Generation Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • The next few steps require a soldering iron.

  • The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.

  • Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

  • Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light continuous tension while the soldering iron heats up the connection. As soon as the solder melts and the lead slides out, immediately lift the solder tip off the connection to avoid damage.

次の作業では、半田ごてが必要です。

電池のリード線の端は、ロジックボードの小さな穴を通して、少量のハンダで固定されています。

白電池のリード線の露出部をハンダごての先で加熱すると同時に、ピンセットでリード線の絶縁体をつかみながら接続部から引き離します。

電子部品はデリケートなため、飯田ごてからロジックボードに伝わる熱量を抑えることが重要です。簡単な方法は、はんだごてが接続部を加熱している間、電池のリード線を軽く引っ張り続けることです。はんだが溶けてリード線が滑り落ちたら、すぐにはんだごてを持ち上げて接続部から離し、損傷を防ぐことができます。

[* icon_note] The next few steps require a soldering iron.
[* icon_note] The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.
-[* black] Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.
+[* black] Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using [product|IF145-020|tweezers] to grasp the lead by the insulation.
[* icon_caution] Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light continuous tension while the soldering iron heats up the connection. As soon as the solder melts and the lead slides out, immediately lift the solder tip off the connection to avoid damage.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0