crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

LeapFrog LeapPad 2 Front Cover Replacement

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:05crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:03crwdne2931653:0
LeapFrog LeapPad 2 Front Cover Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 LeapFrog LeapPad 2 Front Cover Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

  • Use a Phillips #1 screwdriver to remove the following screws:

  • One 5.5mm Phillips screw holding the screen assembly.

  • Two 8.0mm Phillips screws holding the motherboard.

  • Two 6.0mm Phillips screws holding the game cartridge slot.

  • One of these screws also holds a black plastic bracket for the front camera, and the bracket is loose once the screw is removed. Set the bracket aside if it falls out.

  • Remember to replace the bracket during this step of reassembly if it was removed.

  • Three 6.0mm Phillips screws holding the auxiliary board.

  • Be careful not to damage the gray ribbon cable connecting the auxiliary board when removing these three screws.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0