crwdns2933423:0crwdne2933423:0

Remplacement du fusible thermique Bosch Ergomixx CNHR26

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:05crwdne2931653:0
Bosch Ergomixx CNHR26 Heat Fuse Replacement, Inspect the faulty: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Bosch Ergomixx CNHR26 Heat Fuse Replacement, Inspect the faulty: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Inspect the faulty
  • The heat fuse (white component 'Y51 H 120...' next to the blue wire) is of the type: 120 degrees Celcius, 3 Amperes and it handles 250VAC

  • Check the heat fuse by measuring the resistance over the heat fuse, it should be very close to 0(mine was 0.03 ohm) if it's working. NOTE: even though it's resistance is 0 it could still be the close to broken. When current current passes through it might build up resistance.

  • My motor did spin with 12v applied directly to it's poles(though not very fast). The fault of my machine was that the heat fuse had "blown off" after replacement it worked perfectly again!

  • The DC motor is specified to 230v and is of a brushed type.

Le fusible thermique (composant blanc 'Y51 H 120...' à côté du fil bleu) est du type : 120 degrés Celsius, 3 Ampères et il gère 250VAC

Vérifiez le fusible thermique en mesurant la résistance sur le fusible thermique, il devrait être très proche de 0 (le mien était de 0,03 ohm) s'il fonctionne. REMARQUE : même si sa résistance est de 0, elle peut toujours être proche de la rupture. Lorsque le courant passe à travers, il peut créer une résistance.

Mon moteur a tourné avec 12v appliqué directement sur ses pôles (mais pas très vite). Le défaut de ma machine était que le fusible thermique avait "soufflé" après remplacement il fonctionnait à nouveau parfaitement !

Le moteur à courant continu est spécifié à 230 V et est de type balayé.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0