crwdns2933423:0crwdne2933423:0

Reparar una DS Lite que no carga

crwdns2935425:02crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
Repairing a Nintendo DS that is not charging: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Repairing a Nintendo DS that is not charging: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Repairing a Nintendo DS that is not charging: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Remove the faulty EM10 filter. Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers, being careful not to pull the copper tracks off the motherboard.

  • A replacement EM10 filter is available HERE (as at 01/01/12) no doubt other suppliers exist

  • Solder new EM10 filter into place, ensuring correct orientation. If required, check the new filter with a multimeter to confirm before installing.

  • Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan

  • Bypassing the EM10 filter may affect the system performance and is not recommended

Quita el filtro EM10 defectuoso. Usa un cautín para derretir la soldadura y, de manera suave, separa el filtro de la placa utilizando unas pinzas. Ten cuidado y no tires de las pistas de cobre de la placa.

Insertar traducción aquí

Suelda el nuevo filtro EM10 en su lugar, asegúrate de posicionarlo de forma adecuada. De ser necesario, revisa el nuevo filtro con un multímetro para confirmar su funcionamiento antes de instalarlo.

Método alternativo: Haz un puente de soldadura entre las pistas correspondientes de cada par, amarillo con amarillo y azul, celeste con azul celeste.

Eliminar el filtro EM10 puede afectar el rendimiento del dispositivo y no es recomendable.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0