Geneva XS Demontage

crwdns2936071:01crwdne2936071:0

Disable any power supply:

crwdns2936071:02crwdne2936071:0

The metal grille, in the front of the device by pry remove. Here is a thin plastic or metal object to use (in the picture is a letter opener to see), a coin is actually too thick. This can be a little hard!

crwdns2936071:03crwdne2936071:0

Remove the six screws with a PH2 screwdriver

crwdns2936071:04crwdne2936071:0

Now the electronics can be removed from the carcass.

crwdns2936071:05crwdne2936071:0

With a PH1 screwdriver, the two remaining screws which hold the two larger boards arranged above each other can be removed.

crwdns2936071:06crwdne2936071:0

When removing the board, be sure to watch out for the soldered cables, which will not let you play too much.

crwdns2936071:07crwdne2936071:0

Now the media panel can be removed together with the bottom chip. It is essential to pay attention to the plug contacts between them. (see 2nd picture)

crwdns2936071:08crwdne2936071:0

This can then easily be deducted upwards.

crwdns2936071:09crwdne2936071:0 — Assembly

The assembly is actually the same backwards.