crwdns2933423:0crwdne2933423:0

Comment réparer un chargeur magnétique Apple MagSafe

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:09crwdne2931653:0
How to Repair an Apple Magsafe Charger Magnetic End: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • once the plastic has been cleared away you should see a small green circuit board with the remnants of the wires you cut off earlier still attached

  • Use a soldering iron to melt and lift away the old wires

  • NOTE: Pay attention to where the leads go so you can reconnect them to the same place when it's time for re-assembly But it should be fairly obvious that the shield wire has been split into two strands and soldered to the back and front of the circuit board, with the central wire (covered with a white insulator) connected directly to the bottom left corner of the circuit board.

Une fois que le plastique a été enlevé, vous devriez voir un petit circuit imprimé verte avec les restes des fils que vous avez coupés plus tôt, encore joints.

Utilisez un fer à souder pour dessouder les anciens fils.

Faites attention à l'endroit où les fils sont soudés, afin que vous puissiez les reconnecter au même endroit quand il sera temps de les réassembler. Normalement il devrait paraître très évident que le câble de blindage/masse est séparé en deux et soudé à l'arrière et à l'avant du circuit imprimé.

De même, le câble central (protégé par une gaine) se soude directement au coin inférieur gauche du circuit imprimé.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0