crwdns2933423:0crwdne2933423:0

Desmontaje de la plancha de vapor Tefal Turbo Pro 400

crwdns2935425:012crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:012crwdne2931653:0
Tefal Turbo Pro 400 Steam Iron Disassembly, Checking the thermostat: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Tefal Turbo Pro 400 Steam Iron Disassembly, Checking the thermostat: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Checking the thermostat
  • You can now inspect the thermostat. This comprises a bimetallic strip which opens or closes a pair of contacts. The contacts may need cleaning as a result of ingress of water.

  • You can clean the contacts with switch cleaner fluid (available in an aerosol) and a small piece of fine emery paper. Ensure that the contacts snap open and closed when you apply light pressure to one side or the other of the bimetallic strip.

  • On this iron, perhaps slightly unusually, there is a second pair of normally closed contacts which may have suffered corrosion. If you know what these are for, please leave a comment on this Instructable. My guess is that they are a safety cut-out to prevent overheating and fire if the iron is left standing flat while switched on.

  • Identify the connections to the element and test the resistance between them with a multimeter. It should be around 30 ohms (this iron is rated at 240V 2KW).

Ahora puedes inspeccionar el termostato. Este comprende una tira bimetálica que abre o cierra un par de contactos. Los contactos pueden necesitar limpieza como resultado de la entrada de agua.

Puedes limpiar los contactos con líquido limpiador de interruptores (disponible en aerosol) y un trozo pequeño de papel de lija fino. Asegúrese de que los contactos se abran y cierren cuando apliques una ligera presión a un lado o al otro de la tira bimetálica.

En esta plancha, tal vez un poco inusual, hay un segundo par de contactos normalmente cerrados que pueden haber sufrido corrosión. Si sabes para qué sirven, deja un comentario en este manual. Mi conjetura es que son un corte de seguridad para evitar el sobrecalentamiento y el fuego si la plancha se deja plana mientras está encendida.

Identifica las conexiones al elemento y prueba la resistencia entre ellas con un multímetro. Debe ser de alrededor de 30 ohmios (esta plancha tiene una potencia nominal de 240V 2KW).

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0