iPhone 6s 上元件排线更换

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935425:09crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:09crwdne2931653:0

Remove the following five Phillips screws:
Two 2.5 mm screws set into the left edge of the rear case
One 2.1 mm Phillips #000 screw set into the left edge of the rear case
Two 2.1 mm screws set into the right edge of the rear case
If you overtighten these screws during reassembly, your power and volume buttons may not click properly. Check the clicking action on each button before you continue with reassembly.

卸下图中的5颗Phillips螺丝。
位于后盖左侧边缘的2颗2.5mm螺丝。
位于后盖左侧边缘的1颗2.1mm Phillips #000螺丝。
位于后盖右侧边缘的2颗2.1mm螺丝。
如果你在组装时将这些螺丝拧得太紧，你的电源和音量键可能无法正常按下。请在继续组装前检查每一个按键能否正常按下。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0