crwdns2933423:0crwdne2933423:0

UDI U818A Drone Cover Replacement

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:02crwdne2931653:0
UDI U818A Drone Cover Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 UDI U818A Drone Cover Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Remove the single 5 mm screw from the head lamp using a Phillips #000 screwdriver.

  • Remove the head lamp from the rest of the drone.

  • Disconnect the electronics from the frame of the drone by pulling each arm out of the hole in the frame holding it in place.

  • Do not try to separate the frame from the electronics yet! Check to see if there is tape holding the head lamp wires in place underneath the electronics.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0