Use tweezers to pull the five ribbon cables horizontally out of their clips.

Use a spudger or your fingernail to flip up the four, small retaining flap, or zero insertion force (ZIF) connectors. Then, pull the ribbon cable out to disconnect it.

Remove the green tape using your fingernail. Then, use a spudger to pry the one antenna cable connector straight up from the board.

Use tweezers or a spudger to pry up each side of the flat-topped connector. Then, lift the one connector straight up from its socket.

Use tweezers or your fingers to pull the two double-bundled cables up and away from the connector in the same direction that the individual wires are running.