crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Electronics Skills Kit 101

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:014crwdne2931653:0
Electronics Skills Kit 101: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Electronics Skills Kit 101: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Electronics Skills Kit 101: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Bend the leads of the small red diode and insert them into the terminal marked D1.

  • Make sure that the cathode (marked by a small black band) lines up with the white stripe to the left of where it says D1 on the circuit board.

  • Use the same method you used to solder the resistors to the board to install the diode.

Piega le gambe del piccolo diodo rosso ed infilalo nel terminale chiamato D1.

Assicurati che il catodo (indicato da ina piccola banda nera) sia allineato con la striscia bianca a sinistra della scritta D1 sulla scheda logica.

Usa lo stesso metodo usato per saldare le resistenza alla scheda per installare il diodo.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0