crwdns2933423:0crwdne2933423:0

Magic Trackpad Klick-Feedback justieren

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:02crwdne2931653:0
Magic Trackpad Click Adjustment: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Magic Trackpad Click Adjustment: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Use a plastic opening tool to separate the adhesive securing the back panel's left, right, and top edges.

  • Do not pry along the bottom (the edge opposite the battery compartment). There are a bunch of retaining clips that may break if you start from the bottom.

  • Be extremely careful in lifting off the lower panel. The primary CPU/chip on the circuit board (marked in red in the second photo) is affixed to the back panel with a blob of glue. Failure to carefully slice through the glue from the chip/panel can result in the chip being torn from the circuit board, which WILL destroy your trackpad.

  • After slicing through all the adhesive, the lower panel lifts right off.

Verwende ein Plastiköffnungswerkzeug, um den Klebstoff unter dem linken, rechten und oberen Rand der Rückabdeckung zu lösen.

Setze den Hebel nicht unten (am Rand gegenüber des Akkufachs) an. Dort befinden sich Halteklammern, die sonst brechen könnten.

Sei beim Anheben des unteren Panels extrem vorsichtig. Die primäre CPU/Chip auf der Platine (im zweiten Foto rot markiert) ist mit etwas Kleber an der Rückabdeckung befestigt. Wenn der Kleber zwischen Chip und Abdeckung nicht sorgfältig durchtrennt wird, kann der Chip von der Platine abgerissen werden, was dein Trackpad UNBRAUCHBAR machen wird.

Nachdem alle Klebestellen getrennt wurden, lässt sich die Rückabdeckung abnehmen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0