crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement de la carte mère du HTC Excalibur

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:03crwdne2931653:0
HTC Excalibur Logic Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 HTC Excalibur Logic Board Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 HTC Excalibur Logic Board Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.

  • Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.

  • After loosening the case, remove it.

  • When taking the cover off, make sure not to snap any of the clips that are attached to the phone.

  • There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

Après avoir retiré les bouchons en caoutchouc sur le dessus, il devrait y avoir six vis apparentes. Retirez-les à l'aide du tournevis T6.

Ensuite, utilisez le spudger pour desserrer le boîtier sous le bord métallique brillant. Faites tout le tour du téléphone jusqu'à ce qu'il soit complètement desserré.

La coque est super collée et n'endommagera pas le téléphone de manière permanente une fois retirée, mais vous devez toujours faire preuve de prudence.

Après avoir desserré le boîtier, retirez-le.

Il y a un fil qui relie à la fois le haut et le bas du boîtier. Si vous ne faites pas attention lorsque vous retirez le boîtier, vous risquez de casser le fil.

[* black] After removing the rubber stoppers on top, there should be six exposed screws. Remove these using the T6 screwdriver.
[* black] Next, use the spudger to loosen the case underneath the shiny metal edge. Go all the way around the phone until completely loosened.
- [* icon_note] The case is superglued on and will not permanently damage the phone when removed, but you should still use caution.
[* black] After loosening the case, remove it.
+ [* black] When taking the cover off, make sure not to snap any of the clips that are attached to the phone.
[* icon_caution] There is a wire that connects both the top and bottom of the case. If you are not careful when removing the case, you might snap the wire.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0