crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Remplacement de la batterie de l'iPhone 3G

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:014crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:011crwdne2931653:0
iPhone 3G Battery Replacement, Remove the logic board screws: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Remove the logic board screws

  • Remove the following 8 screws:

  • Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

  • Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

  • One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

  • Note for re-assembly:

  • The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

  • Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

crwdns2935429:0crwdne2935429:0

Retirez les 8 vis suivantes:

Cinq vis cruciformes #00 de 2,3 mm à filetage partiel, qui attachent la carte mère au boîtier arrière.

Deux vis cruciformes #00 de 2,3 mm à filetage total, qui maintiennent la carte mère et la caméra.

Une vis cruciforme #00 de 2,9 mm sous le sticker "Do not remove".

Remarque pour le remontage:

La vis qui est placée près de la camera (en bas à droite en orange) dispose aussi d'une bande métallique qui maintient la caméra en place.

N'oubliez pas de remettre cette bande avant de réinsérer la vis cruciforme #00 de 2,3 mm à filetage total près de la caméra.

+[title] Remove the logic board screws
[* black] Remove the following 8 screws:
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
- [* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera
+ [* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0