crwdns2933423:0crwdne2933423:0

Reemplazo de la batería del iPhone 6s

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:03crwdne2931653:0
iPhone 6s Battery Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Repeat for the second strip.

  • Hold down the battery as you remove the second strip, or the strip may fling the battery when it separates from the case.

  • If you removed both adhesive strips successfully, skip to step 29.

  • If either of the adhesive strips broke off underneath the battery and could not be retrieved, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery in the area of the broken adhesive strip(s).

  • Wait about one minute for the alcohol solution to weaken the adhesive. Use the flat end of a spudger to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • Do not insert the spudger in the area between the volume down (-) button and the top edge of the battery, or you may damage the volume control cable lying underneath. Do not pry against the logic board or you may damage the phone.

  • For alternative methods to unstick the battery, continue with the next step below.

Haz lo mismo con la segunda tira.

Sujeta la batería mientras quitas la segunda tira, porque si no lo haces la batería puede salirse de la carcasa.

Si pudiste remover las dos tiras adhesivas con éxito, salta al paso 29.

Si alguna de las tiras adhesivas se ha roto por debajo de la batería y no se ha podido recuperar, aplica unas gotas de alcohol isopropílico de alta concentración (más del 90%) bajo el borde de la batería en la zona de la(s) tira(s) adhesiva(s) rota(s).

Espera aproximadamente un minuto para que la solución de alcohol debilite el adhesivo. Utiliza el extremo plano de un spudger para levantar suavemente la batería.

No intentes hacer palanca para sacar la batería. Si es necesario, aplica unas cuantas gotas más de alcohol para debilitar aún más el adhesivo. No deformes ni pinches la batería con la palanca.

No introduzcas la palanca en la zona comprendida entre el botón de bajar el volumen (-) y el borde superior de la batería, ya que podrías dañar el cable de control de volumen que se encuentra debajo. No hagas palanca contra la placa lógica o podría dañar el teléfono.

Si quieres conocer métodos alternativos para despegar la batería, continúa con el siguiente paso.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0