crwdns2933423:0crwdne2933423:0

Reemplazo de entrada de audífonos y Hold Switch de el iPod Classic

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
iPod Classic Headphone Jack & Hold Switch Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iPod Classic Headphone Jack & Hold Switch Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • If you're just trying to remove the rear panel, you can skip Steps 30 and 31.

  • If your replacement headphone jack includes the white plastic hold switch, simply reinstall the replacement headphone jack. When replacing the hold switch assembly note the locating pin near the hole the silver screw position, concentrate on locating that and the rest falls into place. Once it's all screwed in remember to peal the backing tape off the contact pad just along from the jack.

  • If your replacement part does not include the plastic hold switch, follow the next steps to transfer the plastic hold switch to your new headphone jack.

  • Remove the single Phillips screw nearest to the hold switch.

  • Lift the plastic portion of the Hold switch away from the orange ribbon cable.

  • Ensure that the black notch lines up with the gray slider during reassembly of the switch (see picture 2).

Si solo estás tratando de quitar el panel posterior, puedes omitir los pasos 30 y 31.

Si tu conector de auriculares de repuesto incluye el interruptor de retención de plástico blanco, simplemente vuelve a instalar el conector de auriculares de repuesto.

Cuando reemplaces el conjunto del interruptor de retención, observa el pasador de ubicación cerca del orificio en la posición del tornillo plateado, concéntrate al colocarlo y el resto encajará en su lugar. Una vez que esté todo atornillado, recuerda quitar la cinta de respaldo de la almohadilla de contacto justo a lo largo del conector.

Si tu pieza de repuesto no incluye el interruptor de retención de plástico, sigue los siguientes pasos para transferir el interruptor de retención de plástico a su nuevo conector para auriculares.

Retira el único tornillo Phillips más cercano al interruptor de retención.

Levanta la parte de plástico del interruptor de retención para separarlo del cable plano naranja.

Asegúrate de que la muesca negra se alinee con el deslizador gris durante el montaje del interruptor (mira la imagen 2).

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0