crwdns2933423:0crwdne2933423:0

Remplacement du chargeur du Motorola Droid Turbo

crwdns2935425:04crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:04crwdne2931653:0
Motorola Droid Turbo Chargerport Replacement, Removing Solder + Prepping for new port: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Motorola Droid Turbo Chargerport Replacement, Removing Solder + Prepping for new port: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Removing Solder + Prepping for new port
  • Use a copper braid and soldering iron to remove all of the solder from the contacts and holes. It is soooo important to remove ALL solder before proceeding. If you are having trouble removing solder, clean with 99% isopropyl alcohol, reapply flux and try again. Sometimes it is helpful to ADD more low heat solder and then remove it.

  • After you remove the solder you will be left with a brownish gunk/sludge from caramelized flux. This needs to be removed. Use 99% isopropyl and a qtip. When you are finished your board should look like the one in the second picture and you should be able to see clearly right through the holes.

Utilisez une tresse de cuivre et un fer à souder pour retirer toute la soudure des contacts et des trous. Il est tellement important d'enlever TOUTE la soudure avant de continuer. Si vous rencontrez des difficultés pour retirer la soudure, nettoyez avec de l'alcool isopropylique à 99 %, réappliquez du flux et réessayez.

Après avoir retiré la soudure, vous vous retrouverez avec une crasse / boue brunâtre provenant du flux caramélisé. Cela doit être supprimé. Utilisez de l'isopropyle à 99 % et un coton-tige. Lorsque vous avez terminé, votre planche devrait ressembler à celle de la deuxième image et vous devriez pouvoir voir clairement à travers les trous.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0