crwdns2935425:011crwdne2935425:0
-
To swap a Bill dispenser head, your first step is to pull the dispenser out so that you can work with it.
-
Then, unplug all of the cords that are plugged into the board. There should be four across the bottom and two on the side.
-
Now that it’s unplugged, on either side is a plate with four screws which are holding the dispenser head to the rest of the machine. Remove these screws on both sides and take the plates off as well. You will also need to remove the safe door from (at least) the section that you want to remove.
-
Once this is accomplished tilt the head to the left which will allow you to remove the belt that is located on the back left had side. Remove the belt and lift the head from the dispenser.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0