crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Sustitución de la Placa Base del Toshiba Tecra 8100

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:03crwdne2931653:0
Toshiba Tecra 8100 Motherboard Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Toshiba Tecra 8100 Motherboard Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Toshiba Tecra 8100 Motherboard Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • The F4 screws are located along the two long sides of the edge of the battery panel. The F6 screws are located along the opposite side of the bottom of the laptop from the battery. The F10 screws are located at each of the four corners of the bottom of the laptop.

  • Remove all screws labeled F4, F6, and B10 from the back panel using the Phillips #00 screwdriver.

  • There should be 8 F4 screws, 6 F6 screws, and 3 B10 screws.

  • (If screws are severely stripped, the use of pliers and tweezers may be necessary.

Los tornillos F4 están ubicados a lo largo de los dos lados largos del borde del panel de la batería. Los tornillos F6 se encuentran en el lado opuesto de la parte inferior de la computadora portátil de la batería. Los tornillos F10 se encuentran en cada una de las cuatro esquinas de la parte inferior de la computadora portátil.

Retira todos los tornillos etiquetados F4, F6 y B10 del panel posterior con el destornillador Phillips #00.

Debe haber 8 tornillos F4, 6 tornillos F6 y 3 tornillos B10.

(Si los tornillos están muy desgastados, puede ser necesario el uso de alicates y pinzas.

[* black] The F4 screws are located along the two long sides of the edge of the battery panel. The F6 screws are located along the opposite side of the bottom of the laptop from the battery. The F10 screws are located at each of the four corners of the bottom of the laptop.
[* black] Remove all screws labeled F4, F6, and B10 from the back panel using the Phillips #00 screwdriver.
[* black] There should be 8 F4 screws, 6 F6 screws, and 3 B10 screws.
-[* black] (If screws are severely stripped, the use of pliers and tweezers may be necessary.
+[* black] (If screws are severely stripped, the use of pliers and [product|IF145-020|tweezers] may be necessary.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0