crwdns2933423:0crwdne2933423:0

iPod Nano 第一世代 バッテリー&ロジックボードの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:06crwdne2931653:0
iPod Nano 1st Generation Battery & Logic Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Disconnecting the following two ribbon cables may be challenging. To prevent straining the cables or connectors, you can only separate the two halves of the iPod about 1/2 inch during the process.

  • Use a spudger to flip up the black plastic tab holding the orange display ribbon in place. The black tab will rotate up 90 degrees, releasing the ribbon cable.

以下の2本のリボンケーブルの取り外しは難しいかもしれません。ケーブルやコネクタに負担をかけないように、作業中はiPodの2つの半分を約1/2インチ(約1.27cm)しか離さないようにしてください。

スパッジャーを使用して、オレンジ色のディスプレイリボンを固定している黒いプラスチックのタブを押し上げます。黒いタブが90度回転し、リボンケーブルが外れます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0