crwdns2933423:0crwdne2933423:0

iPod Nano 第一世代 バッテリー&ロジックボードの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
iPod Nano 1st Generation Battery & Logic Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Remove any kapton tape over the screws, if necessary.

  • Remove the following 3 screws:

  • Two 3 mm Phillips screws near the dock connector.

  • One 4 mm Phillips screw along the edge of the logic board.

  • During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

必要に応じて、ネジの上のカプトンテープをすべて取り外します。

以下の3つのネジを取り外します。

ドックコネクタ付近の2つの3mmプラスネジ。

ロジックボードの端に沿って取り付けられている1つの4mmプラスネジ。

再組み立ての際には、取り外したテープやプラスチックを必ず元の位置に戻してください。これにより、ロジックボードとリアパネルの間のショートを防止できます。使用しているテープが使用できない場合は、カプトンテープをオンラインで購入できます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0