crwdns2933423:0crwdne2933423:0

Batteria e scheda logica iPod Nano 1a generazione

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:01crwdne2931653:0
iPod Nano 1st Generation Battery & Logic Board Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Remove any kapton tape over the screws, if necessary.

  • Remove the following 3 screws:

  • Two 3 mm Phillips screws near the dock connector.

  • One 4 mm Phillips screw along the edge of the logic board.

  • During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.

Rimuovi eventuale nastro Kapton sopra le viti, se necessario.

Rimuovi le seguenti 3 viti:

Due viti a croce Phillips da 3 mm vicino al connettore dock.

Una vite a croce Phillips da 4 mm lungo il bordo della scheda logica.

Durante il rimontaggio, assicurati di rimettere qualsiasi nastro o plastica che hai rimosso. Questo impedirà eventuali cortocircuiti tra la scheda logica e il pannello posteriore. Se il tuo nastro non è riutilizzabile, il nastro Kapton può essere acquistato online.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0