Olympus E-Pl1 Sensor Assembly Removal

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:02crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:05crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:05crwdne2931653:0

Olympus E-Pl1 Sensor Assembly Removal: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0

Olympus E-Pl1 Sensor Assembly Removal: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

In the upper left hand corner, use the #000 Phillips screwdriver to remove the 6.0 mm screw.
Retain the copper washer held in by this screw.
Using tweezers gently lift the copper grounding strip.
Do not tear the strip as you pull it off, it must stay attached to the main camera body.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0