crwdns2933423:0crwdne2933423:0

Instructions pour l'iOpener (ancien modèle)

crwdns2935425:04crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:04crwdne2931653:0
iOpener (Legacy) Instructions: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Lay the iOpener flat on the edge of the device, over an adhesive seal you wish to heat. Smooth the iOpener along the surface to ensure good contact with the device.

  • Let the bag sit on the device for approximately 90 seconds before attempting to open the front panel.

  • At this point you should be able to begin prying under the screen with a plastic opening tool. Be sure to see your device's specific guide for where and how to do this.

  • Throughout the procedure you may need to reheat the iOpener. To prevent overheating the iOpener, always wait at least two minutes before microwaving again. Do not microwave the iOpener for more than one minute at a time.

Posez l’iOpener à plat sur le bord de l’appareil, sur le joint adhésif que vous souhaitez chauffer. Lissez l’iOpener le long de la surface pour assurer un bon contact avec l’appareil.

Laissez le sac reposer sur l’appareil pendant environ 90 secondes avant d’essayer d’ouvrir le panneau avant.

À ce stade, vous devriez pouvoir commencer à faire levier sur l’écran avec un outil d’ouverture en plastique. Assurez-vous de consulter le tutoriel spécifique de votre appareil, pour savoir où et comment le faire.

Tout au long de la procédure, vous devrez peut-être réchauffer l’iOpener. Pour éviter la surchauffe de l’iOpener, attendez toujours au moins deux minutes avant de le passer à nouveau au micro-ondes. Ne mettez pas l’iOpener au micro-ondes plus d’une minute à la fois.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0