Kenwood Chef: Replacing the SER1018 Planetary set

crwdns2936071:01crwdne2936071:0 — Remove the locking latch knob

Remove the button

crwdns2936071:02crwdne2936071:0 — Remove the sun gear

Unscrew the hex nut

crwdns2936071:03crwdne2936071:0 — Bottom of the machine

Remove the bottom of the machine

crwdns2936071:04crwdne2936071:0 — Fast and medium speed outputs

Unscrew the screws on each side of the circular discs to remove the circular plastic discs

crwdns2936071:05crwdne2936071:0 — Housing cover

Unscrew the three Torx screws

crwdns2936071:06crwdne2936071:0 — The challenge: loosen the hidden screw

It is not necessary to proceed to the next step if the plastic drive wheel has been removed

crwdns2936071:07crwdne2936071:0 — Special Tool

I modified an open end wrench to drive a Tx20 bit

crwdns2936071:08crwdne2936071:0 — Open the housing

Remove the guides (red mark). They can be reassembled after closing the housing

crwdns2936071:09crwdne2936071:0 — Planetary

The former one has a cross fromation.

crwdns2936071:010crwdne2936071:0 — Training axis

The former one has a cross patteren

crwdns2936071:011crwdne2936071:0 — Labels

Cod. SER1018: Plastic bag containing the three spare parts

crwdns2936071:012crwdne2936071:0 — Fitting the gears

Place each gear on the axis

crwdns2936071:013crwdne2936071:0 — Crank Case Assembly

There is a lot of greasein the case. Spread the grease on the surfaces that need it.

crwdns2936071:014crwdne2936071:0 — Hidden screw

Screw the hidden screw back in