Reveal plug in to inverter board

Use small hemostat or tweezers to grasp end of inverter plug in and pull out.

The LCD is now free to be removed.

To install an inverter just lift the cover up higher and remove it.

I was able to leave the left end of the clutch cover 'mostly' in place and unplug both ends of the inverter.

When replacing the clutch cover inspect the back. I had both ends 'sticking out' a little and had to break the little plastic tabs to make it flush again - or I could have started over and removed everything to properly replace the clutch cover. On a 5 year-old machine I elected to break plastic tabs off the clutch cover.