Zebra GK420d Printhead Replacement

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:03crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:03crwdne2931653:0

Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove the top cover of the lid.

Remove the 5 Phillips Screws.
Remove the recessed Phillips Screw. It may not be possible to use a driver to remove this screw.
Gently unplug the two ribbon cables attached to the underside of the lid cover.
Note which direction the contacts on the ribbon cables are facing for reassembly.
If there is enough slack on the ribbon cable traveling down the side of the printer, it is not necessary to unplug it. The lid may rest next to the printer.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0