crwdns2933423:0crwdne2933423:0

Remplacement de la tête d'impression Zebra GK420d

crwdns2936315:0crwdne2936315:0
crwdns2936317:0crwdne2936317:0
crwdns2931653:03crwdne2931653:0
Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Zebra GK420d Printhead Replacement, Remove the top cover of the lid.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the top cover of the lid.
  • Remove the 5 Phillips Screws.

  • Remove the recessed Phillips Screw. It may not be possible to use a driver to remove this screw.

  • Gently unplug the two ribbon cables attached to the underside of the lid cover.

  • Note which direction the contacts on the ribbon cables are facing for reassembly.

  • If there is enough slack on the ribbon cable traveling down the side of the printer, it is not necessary to unplug it. The lid may rest next to the printer.

Retirez les 5 vis cruciformes.

Retirez la vis cruciforme encastrée. Il peut ne pas être possible d'utiliser un tournevis pour retirer cette vis.

Débranchez doucement les deux câbles plats attachés sous le couvercle du couvercle.

Notez dans quelle direction les contacts sur les câbles plats sont orientés pour le remontage.

S'il y a suffisamment de mou sur le câble ruban qui descend le long du côté de l'imprimante, il n'est pas nécessaire de le débrancher. Le couvercle peut reposer à côté de l'imprimante.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0