crwdns2933423:0crwdne2933423:0

Canon PowerShot SX200 IS Lens Disassembly

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:09crwdne2931653:0
Canon PowerShot SX200 IS Lens Disassembly, Iris and image stabiliser ribbons: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Canon PowerShot SX200 IS Lens Disassembly, Iris and image stabiliser ribbons: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Iris and image stabiliser ribbons
  • With the lens back plate removed, temporarily replace one of the 4 screws which secured it. It will not be possible to drive it fully home; only tighten it until resistance is felt.

  • Lift out the three zoom motor gears and put them aside.

  • Lift the lens off the bench and using a small flat screwdriver, gently turn the gear teeth which the last zoom motor gear engaged with until the lens is open approximately half way.

  • Now feed the two ribbons protruding through a slot in the barrel back into the lens.

  • Resting the lens face-down on the bench, retract it to the closed position by turning the gear teeth in the opposite direction. Remove the screw you temporarily reinserted.

  • Follow the reverse procedure for reassembly.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0