crwdns2933423:0crwdne2933423:0

Game Boy Pocket Tasten Austausch

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
    If you need to replace the face buttons on a Game Boy Pocket (model MGB-001) due to worn-out buttons or to customize your console, use this guide to remove and replace the buttons. No prior experience or soldering is required.
    The Game Boy Pocket has five buttons located on the front of the device:
    * Directional Pad (D-Pad)
    * A
    * B
    * Start
    * Select
    Before beginning, ensure that the console is powered off by moving the power switch located on the top left corner to the left position. It is recommended that you remove the two AAA batteries located on the lower backside of the console as well as any game cartridges from the slot on the top of the console.

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0 — Schrauben herausdrehen

      Lege den Game Boy mit der Vorderseite nach unten auf eine saubere glatte Fläche.

      crwdns2936071:02crwdne2936071:0 — Öffnen

      Trenne mit den Händen vorsichtig die beiden Gehäuseteile.

      crwdns2936071:03crwdne2936071:0 — Schrauben der Hauptplatine

      Drehe die drei Kreuzschlitzschrauben #1 an der Hauptplatine heraus.

      crwdns2936071:04crwdne2936071:0 — Befestigung des Flachbandkabels

      Löse die Klammer am Flachbandkabel mit einem Plastiköffnungswerkzeug.

      crwdns2936071:05crwdne2936071:0 — Lösen des Flachbandkabels

      Löse das Flachbandkabel mit einem Plastiköffnungswerkzeug.

      crwdns2936071:06crwdne2936071:0 — Hauptplatine entfernen

      Fasse das schwarze Teil, welches auf er Hauptplatine aufgesetzt ist, fest an und hebe die Platine hoch.

      crwdns2936071:07crwdne2936071:0 — Tasten entfernen

      Entferne die drei Tastenabdeckungen aus Silikon mit den Fingern.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0