While holding the plastic retainer down against the board, use the tip of a spudger to pry the PRAM battery out of its housing.
Failure to hold the plastic retainer down during the prying process may result in it tearing off the motherboard.
Before installing the heat sink onto the motherboard, it is essential to apply a new layer of thermal paste. This guide will show you how to do it.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0
crwdns2931507:0crwdne2931507:0
crwdns2931509:0crwdne2931509:0
crwdns2931511:0crwdne2931511:0
crwdns2931513:0crwdne2931513:0
crwdns2931515:0crwdne2931515:0
crwdns2931517:0crwdne2931517:0
crwdns2931519:0crwdne2931519:0
crwdns2931521:0crwdne2931521:0
crwdns2931523:0crwdne2931523:0
crwdns2931525:0crwdne2931525:0