crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

iPod Nano 第5世代のロジックボードアセンブリの交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
iPod Nano 5th Generation Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 iPod Nano 5th Generation Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 iPod Nano 5th Generation Logic Board Assembly Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Use a heat gun to soften the adhesive underneath the camera/microphone cover.

  • Pry the camera/microphone cover off the case with a metal spudger and remove it.

  • It is extremely difficult, if not impossible, to avoid damaging the iPod case near the camera. While this will not affect the iPod's functionality, it will hurt its cosmetic appearance.

  • You can try this alternative method for removing the cover:

  • Use a hot glue gun to apply a bead of glue across the cover.

  • Move the nozzle in the glue for 20 seconds to heat the lens adhesive holding the lens in place.

  • Press a spudger into the hot glue and hold it in place until the glue cools and hardens.

  • Pull on the spudger with firm steady force, while using a fingernail to pry on the cover edge.

ヒートガンを使って、カメラ/マイクカバーの下に留められた接着剤を柔らかくします。

メタル製スパッジャーを使って、ケースからカメラ/マイクカバーをこじ開けて、取り外します。

カメラ付近のiPodケースにダメージを与えないようにすることは、不可能ではなくとも、極めて難しいです。この作業は、iPodの機能には影響しませんが、外観は損なわれます。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0