crwdns2933423:0crwdne2933423:0

Disassembling Canon PowerShot SX200 IS

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:014crwdne2931653:0
Disassembling Canon PowerShot SX200 IS: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Disassembling Canon PowerShot SX200 IS: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Disassembling Canon PowerShot SX200 IS: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • On the bottom left hand side of the lens assembly there is a connector with a red and a black wire going to the speaker. Disconnect this, taking great care not to strain the wires or especially the ribbon that the socket is mounted on.

  • At the rear top left hand side of the lens assembly is a ribbon cable connecting it to the flash module. Disconnect this.

  • (Note the transparent protective insulation covering the flash board just below this connector. Do not remove this as the board may still have a dangerous high voltage on it from the flash capacitor behind.)

  • Remove a screw from the top right hand side of the flash module, and separate the flash module from the lens assembly.

  • (On reassembly, hold the flash head closed while refitting it to the lens assembly.)

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0