crwdns2933423:0crwdne2933423:0

Repairing Microsoft Wedge Touch Mouse Battery Cover Retaining Clip

crwdns2935425:010crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:010crwdne2931653:0
Repairing Microsoft Wedge Touch Mouse Battery Cover Retaining Clip: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Push down upper PCB, reinsert and tighten the 2 black screws, if you removed all 4 during disassembly, remember to put the lens and iris back under the upper PCB before pushing it down and tightening all 4 black screws.

  • Reinstall the narrow brown ribbon, starting with the retaining clip pulled loose, there is a darker brown reinforcing strip on the non contact side of the ribbon, the edge of this strip can be pushed on with your fingernail or a small flat blade screw driver or tweezers to push the cable in, the clip will push in as the cable is pushed in.

  • Reinstall the white ribbon into both the upper PCB and the PCB attached to the top cover and rotate the black clips into the flat locked position.

  • Hook the thin edge of the top cover over the thin edge of the main body of the mouse.

  • Start closing the case by slipping the plastic retaining pin on the left side into its hole first then push down the right side clip over the metal clip.

  • Reinstall the battery and close the battery cover.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0