Clearing Jammed Printrbot Simple Metal 2014 Hot End

crwdns2935425:02crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:02crwdne2931653:0

Pull off the red Teflon "sock".

The sock may stick to the brass nozzle. If this happens, use a utility knife to separate the nozzle from the sock.
The sock keeps heat even over the hot end. You'll need to put it back on when printing for good results.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0