Electric Shock Warning: There is a high voltage capacitor on the DC PCB board which powers the flash. It is recommended that you use a capacitor discharge tool to ensure the capacitor is fully discharged before proceeding with this guide.
Using a JIS #000 screwdriver, unscrew the two 4.9mm JIS screws which are located underneath the flash.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0
crwdns2931507:0crwdne2931507:0
crwdns2931509:0crwdne2931509:0
crwdns2931511:0crwdne2931511:0
crwdns2931513:0crwdne2931513:0
crwdns2931515:0crwdne2931515:0
crwdns2931517:0crwdne2931517:0
crwdns2931519:0crwdne2931519:0
crwdns2931521:0crwdne2931521:0
crwdns2931523:0crwdne2931523:0
crwdns2931525:0crwdne2931525:0