crwdns2935425:02crwdne2935425:0
crwdns2931653:02crwdne2931653:0
-
Remove the seven Phillips #1 screws holding the battery in place.
-
Detach the battery connector by pulling the connector towards the battery.
-
Remove the battery.
- | [* black] Remove the seven screws that are holding in the battery. They can be seen circled in the picture. |
---|---|
- | [* black] When unscrewed, lift the battery. There will be a cable connected to the battery. Detach this cable from the board and remove the battery. |
- | [* black] Attach the replacement battery cable to the board and reassemble. It can be seen highlighted in picture 2. |
- | [* black] *Note: When reinserting the battery it is easier to put in the long end first and then dropping the other side in. |
+ | [* red] Remove the seven Phillips #1 screws holding the battery in place. |
+ | [* orange] Detach the battery connector by pulling the connector towards the battery. |
+ | [* icon_caution] Pull from the plastic connector, do not pull from the wires. |
+ | [* black] Remove the battery. |
+ | [* icon_note] When reinserting the battery, it is easier to insert from the long end first before lowering the rest of the battery into place. |
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0