crwdns2933423:0crwdne2933423:0

Maak zelf een tool om een condensator te ontladen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:06crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:06crwdne2931653:0
Constructing a Capacitor Discharge Tool: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Repeat the above process for the other side of the resistor.

  • To complete the discharge tool, strip the ends of the wires.

  • To discharge from small points, it may be helpful to cut the exposed ends of wire into a point shape and solder them to maintain the shape. Alternatively, the probes commonly used on multimeters can be soldered to the wires to create a more precise discharge tool.

  • For large electrolytic capacitors used in power supplies, electric motor start circuits, and camera flash units, you may want to solder one end to a large alligator clip and the other to a well insulated screwdriver.

Herhaal het bovenstaande proces ook voor de andere kant van de weerstand.

Om het ontlaadgereedschap te voltooien, strip je de uiteinden van de draden.

Om kleine contactpunten te ontladen, kan het handig zijn om de blootliggende draadeinden in een puntvorm te knippen en ze te solderen om de vorm te behouden. Als alternatief kunnen de sondes, die gewoonlijk op multimeters worden gebruikt, aan de draden worden gesoldeerd om een nauwkeuriger ontladingsinstrument te creëren.

Voor grote elektrolytische condensatoren die worden gebruikt in voedingen, startcircuits voor elektrische motoren en cameraflitsers, kun je het ene uiteinde aan een grote krokodillenklem en het andere aan een goed geïsoleerde schroevendraaier solderen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0