crwdns2933423:0crwdne2933423:0

Maak zelf een tool om een condensator te ontladen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:04crwdne2931653:0
Constructing a Capacitor Discharge Tool: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Constructing a Capacitor Discharge Tool: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Constructing a Capacitor Discharge Tool: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Join the lead leaving the resistor to the stripped end of the wire by twisting the two together.

  • The wire we are using is quite thick, so we inserted the resistor lead down the center of the conductor portion of the wire and twisted the wire against it as tightly as possible.

  • Solder the wire to the resistor.

  • It is essential that enough solder flows through the wire to create a permanent bond between the two pieces.

Verbind de draad van de weerstand en het gestripte uiteinde van de draad door de twee in elkaar te draaien.

De draad die we gebruiken is vrij dik, dus we hebben de weerstandsdraad in het midden van het geleidergedeelte van de draad gestoken en de draad er zo strak mogelijk omheen gedraaid.

Soldeer de draad aan de weerstand vast.

Het is essentieel dat er voldoende soldeertin in de soldeerverbinding vloeit om een permanente verbinding tussen de twee draden te creëren.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0