crwdns2933423:0crwdne2933423:0

Maak zelf een tool om een condensator te ontladen

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936313:0crwdne2936313:0
crwdns2931653:01crwdne2931653:0
Constructing a Capacitor Discharge Tool: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • To construct a capacitor discharge tool, first gather the necessary materials. These include:

  • Two lengths of wire. Minimum wire requirements is 12AWG, 600 volt rating for large electrolytic capacitors used in power supplies, electric motor start circuits and camera flash circuitry

  • A resistor rated to dissipate the amount of thermal energy created when discharging the capacitor. Minimum requirements for resistor is 2k OHM 5w for small capacitors, 20k OHM 5w for large electrolytic capacitors used in power supplies, electric motor start circuits and camera flash circuitry.

  • Shrink tubing

Om een condensator-ontladingstool te kunnen maken, zul je eerst de benodigde materialen moeten verzamelen. Waaronder:

Twee stukken draad. Minimale draadvereisten zijn 4 kwadraatsdraad (12AWG), 600 volt voor grote elektrolytische condensatoren die worden gebruikt in voedingen, elektrische motorstartcircuits en cameraflitscircuits.

Een weerstand geschikt om de hoeveelheid warmte die ontstaat bij het ontladen van condensators af te voeren. De minimumvereisten voor 'n weerstand zijn 2k Ohm 5w voor kleine condensatoren, 20k Ohm 5w voor grote elektrolytische condensatoren die worden gebruikt in voedingen, startcircuits voor elektrische motoren en flitscircuits voor camera's.

Krimpkous.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0