PowerMac G3 All-In-One Teardown

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:06crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936325:0crwdne2936325:0

crwdns2931653:06crwdne2931653:0

PowerMac G3 All-In-One Teardown, Installing RAM: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

PowerMac G3 All-In-One Teardown, Installing RAM: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

PowerMac G3 All-In-One Teardown, Installing RAM: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Installing RAM

Ram used can be 3.3V unbuffered 100 MHz 168-pin SDRAM
Part A: Open the clip on the center steel beam.
Part B: Disconnect the SCSI ribbon cable and IDE ribbon cable and set the cables aside.
Part C: You should now be able to access the three RAM slots.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0