Marshall MS-2 Micro Amp Circuit Board Disassembly

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:03crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:03crwdne2931653:0

Marshall MS-2 Micro Amp Circuit Board Disassembly: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Marshall MS-2 Micro Amp Circuit Board Disassembly: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Marshall MS-2 Micro Amp Circuit Board Disassembly: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Now you must remove the LED from the circuit board.
To do this you will need to use a soldering iron to detach to two pins of the LED from the board. They are the two pins in the lowest leftmost corner of the board.
Be careful to not touch any of the wires with the soldering iron. It might be helpful to remove those with the iron first to get them out of the way.
If you haven't soldered before check out this guide.
Once detached, pull the board straight up to remove.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0