Picstart Plus Development Programmer Teardown

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:01crwdne2931653:0

Picstart Plus Development Programmer Teardown: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Picstart Plus Development Programmer Teardown: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Picstart Plus Development Programmer Teardown: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove 4 Phillips screws located on the back side of the holding plate.
After the screws are removed, remove the case of the development programmer.
Carefully take out the circuit board with component side facing up. Put the case aside.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0