crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

使用手动压扣机安装塑料按扣

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:09crwdne2931653:0
Plastic Snap Installation Using a Hand Press, Quality control: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Quality control: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Plastic Snap Installation Using a Hand Press, Quality control: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Quality control

  • Remove the garment from the press and check that the new snap clicks into the opposing side.

  • A properly secured snap will flatten the cap post into the sock/stud piece. Depending on the type of snap dies used, this will produce one of two outcomes:

  • Three concentric circles visible at the center of the snap (reference image #2)

  • A mushroom dome shape at the center of the snap (reference image #3)

  • If the snap spins in place, the snap isn't secure. Repeat the previous step.

  • If you're replacing both sides of the snap, repeat these steps on the other side, ensuring all the proper dies and pieces are used.

质量检验

将衣物从压机取出，检查新按扣能否与对应侧正常扣合。

正确安装的按扣会使扣帽柱体与套座/扣钉完全压平。根据所用模具类型，将呈现以下两种形态之一：

按扣中心呈现三个同心圆（参见图示#2）

按扣中心形成蘑菇状圆顶（参见图示#3）

若按扣存在松动旋转现象，说明安装不牢固，需重复上一步骤。

如更换按扣双侧部件，请使用正确模具重复上述步骤完成另一侧安装。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0