crwdns2933423:0crwdne2933423:0

Razer Kraken (Kraken TE) Headband Replacement

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:04crwdne2931653:0
Razer Kraken (Kraken TE) Headband Replacement, Desolder the right driver: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Razer Kraken (Kraken TE) Headband Replacement, Desolder the right driver: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Desolder the right driver
  • Desolder the two audio cables.

  • Put a few drops of flux over the tin of each solder.

  • Melt the tin with the soldering iron tip set at 320-350 degrees Celsius.

  • The tin should melt easily, freeing the cable.

  • Do not leave the tip of the soldering iron for more than 4-5 seconds continuously over the pad and do not raise the temperature too high, you may ruin the circuit board.

  • Clean the pitches.

  • Pass with the desoldering braid over the remaining tin, resting the soldering iron tip on top.

  • You can add a little more flux or use a tin remover pump.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0