crwdns2933423:0crwdne2933423:0

MacBook Pro 14インチ 2021 MagSafeポートの交換

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
MacBook Pro 14" Early 2023 MagSafe Port Replacement, Unfasten the MagSafe port: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 MacBook Pro 14" Early 2023 MagSafe Port Replacement, Unfasten the MagSafe port: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 MacBook Pro 14" Early 2023 MagSafe Port Replacement, Unfasten the MagSafe port: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Unfasten the MagSafe port
  • Use a 2IP Torx Plus driver to loosen (don't remove) the two MagSafe Port set screws a few turns above the frame.

  • These screws can strip easily. Make sure to apply constant, downward force to prevent stripping.

  • Use your T5 Torx driver to remove the two 2.7 mm-long screws securing the MagSafe port.

  • These screws are not magnetic—be careful not to lose them.

T2トルクスドライバーを使って、MagSafeポートを固定しているネジを2本緩めます

ネジをまだ外さないでください、フレームの上で数回転緩めるだけです。

ドライバーの状態にもよるが、T3トルクスビットが最適かもしれない。

T5トルクスドライバーを使用して、MagSafeポートを固定している長さ2.7 mmの5IPトルクスプラスネジ2本を取り外します。

これらのネジはマグネットではないため、作業中、紛失しないようにご注意ください。

[title] Unfasten the MagSafe port
[* red] Use a 2IP Torx Plus driver to ***loosen*** (don't remove) the two MagSafe Port set screws a few turns above the frame.
- [* icon_note] In a pinch, you can use a standard T2 Torx driver to loosen these screws. Make sure to apply constant, downward force to prevent stripping.
+ [* icon_note] These screws can strip easily. Make sure to apply constant, downward force to prevent stripping.
[* orange] Use your T5 Torx driver to remove the two 2.7 mm-long screws securing the MagSafe port.
[* icon_note] These screws are not magnetic—be careful not to lose them.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0