crwdns2933423:0crwdne2933423:0

HP EliteBook 840 G7 WLAN-Modul Kabel trennen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:01crwdne2931653:0
HP EliteBook 840 G7 Wi-Fi Module Cable Disconnection, Disconnect the WLAN module cables: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 HP EliteBook 840 G7 Wi-Fi Module Cable Disconnection, Disconnect the WLAN module cables: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 HP EliteBook 840 G7 Wi-Fi Module Cable Disconnection, Disconnect the WLAN module cables: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the WLAN module cables
  • Slide an arm of a pair of angled tweezers under the metal neck of one of the coaxial connectors on the WLAN (Wi-Fi) module, located just below the fan.

  • Lift straight up to disconnect the cable.

  • Repeat to disconnect the second connector.

  • During reassembly:

  • Connect the cable with black tape to the socket with a black arrow below it, and the cable with white tape to the socket with a white arrow.

  • Use tweezers to hold a connector in place over its socket and gently press down with your finger or a spudger—the connector should "snap" into place. If you're having trouble, reposition the head and try again. Don't use excessive force.

Schiebe einen Arm einer gebogenen Pinzette unter den Metallhals eines der Koaxialstecker auf dem WLAN-Modul (Wi-Fi-Modul), der sich direkt unterhalb des Lüfters befindet.

Hebe den Stecker gerade nach oben, um es zu trennen.

Wiederhole den Vorgang, um den zweiten Stecker zu trennen.

Beim Zusammenbau:

Verbinde das Kabel mit dem schwarzen Klebeband mit der Buchse mit dem schwarzen Pfeil darunter und das Kabel mit dem weißen Klebeband mit der Buchse mit dem weißen Pfeil.

Halte den Stecker mit einer Pinzette über seinem Anschluss in Position und drücke ihn vorsichtig mit dem Finger oder einem Spudger nach unten – der Stecker sollte hörbar einrasten. Wenn es nicht gleich klappt, richte ihn neu aus und versuche es erneut. Übe dabei keinen übermäßigen Druck aus.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0