Under where the three M1.7x5.5mm Phillips #000 screws were, you will notice figure eight-shaped washers.
Use a pair of tweezers to remove the washers.
Caution: Keep very careful track of where each washer was removed from. Some washers may contain a stack of two washers. Each washer is a different thickness (down to 0.01mm) and reinstalling them in the wrong spot will result in out of focus images.
You may want to use a digital caliper to measure each washer as you remove them, and record down the washer's thickness and which spot you removed it from.
crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0
crwdns2931507:0crwdne2931507:0
crwdns2931509:0crwdne2931509:0
crwdns2931511:0crwdne2931511:0
crwdns2931513:0crwdne2931513:0
crwdns2931515:0crwdne2931515:0
crwdns2931517:0crwdne2931517:0
crwdns2931519:0crwdne2931519:0
crwdns2931521:0crwdne2931521:0
crwdns2931523:0crwdne2931523:0
crwdns2931525:0crwdne2931525:0