RazorX DLX Electric Skateboard Control Module Replacement

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:05crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:05crwdne2931653:0

RazorX DLX Electric Skateboard Control Module Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

RazorX DLX Electric Skateboard Control Module Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

RazorX DLX Electric Skateboard Control Module Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove the 20 mm Phillips #0 screw.
Disconnect the DC connector. The DC connector can be identified as the connector with only two wires.
Disconnect the power button. It is a temporary switch, which can be identified by its 4-wire configuration.
Disconnect the Hall effect sensor. It can be identified by its 6-wire configuration.
A hall effect sensor is used to tell the board where the motor is in its rotation.
You will need to remove silicone and hot glue to remove the connectors.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0