crwdns2933423:0crwdne2933423:0

Einfassung der USB-Platine entfernen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:04crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:03crwdne2931653:0
USB Board Enclosure Removal, Remove the USB enclosure screws: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 USB Board Enclosure Removal, Remove the USB enclosure screws: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 USB Board Enclosure Removal, Remove the USB enclosure screws: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the USB enclosure screws
  • Use a T8 Torx driver to remove the two 8.9 mm‑long screws securing the USB board enclosure:

  • One screw inside the shell

  • One screw on the bottom of the shell (where the base was)

Nimm einen Torx T8 Schraubendreher und entferne die beiden 8,9 mm langen Schrauben, mit denen die Einfassung der USB-Platine befestigt ist:

Eine Schraube im Inneren des Gehäuses.

Eine Schraube am Gehäuseboden (wo der Fuß war).

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0